Sounds like a damaged screw/gear inside your trailer jack. That specific model is no longer made so for a replacement the upgraded version part # JET-5000 would be your best option. This has a higher capacity so it would work a little quicker too. view full answer...
Since you need more drop than the ball mount you have now which has a friction sway control attached to side of it the easiest solution would be to go with a bracket like the part # RP26003 which fits over the ball mount platform and allows you to basically use whichever ball mount you need to provide correct rise/drop to tow trailer level. We also have weld on tabs for the bracket as well like with the # 3442.
I also attached a link to a page that details how to pick out the correct... view full answer...
The correct bearing kit for your 2009 Rockwood Ultra Lite camper would be the part # BK2-100 since your trailer would have either a 3,500 or 4,400 lb trailer axle and this kit fits both. view full answer...
You shouldn't have any issue replacing the lower 2 watt light fixture in your RV with the 3.24 watt Gustafson Reading Light # 277-000334, but the potential for any issues is dependent on what else is connected to that circuit and what the line is rated for.
I can't imagine that this circuit on your Forest River Rockwood is cutting it so close that anything over a 2 watt fixture would be too much for it to handle but the only way to be sure would be to determine all the loads connected... view full answer...
From what I could find, there are a few different models/options for a 2007 Forest River Rockwood Ultra Lite and the weights do vary a bit. However, none of said options will put your tongue weight anywhere over 2,000 pounds.
With that said, the etrailer.com Electric Jack w/ Footplate # EJ-3520-WBX will be a great option. This is rated to lift up to 3,500 pounds and includes a drop leg for increased lift and can save time when raising or lowering. The LED light on the front of the jack... view full answer...
While we do not sell these wheel caps in white, there are certainly ways to effectively paint the Lionshead Trailer Wheel Center Cap - 3.19" Pilot - Stainless Steel # LHCS102. You will likely want to sand down the wheel cap, then coat it with primer. Then you should be all set to put some white paint of your liking on it so that it will match your white wheels. There are many different ways to accomplish this; I recommend stopping into your local hardware store or paint shop and asking... view full answer...
The least expensive option for a camera setup for your Rockwood that was pre-wired for a Furrion setup is the # FOS43TASF. Anything else would be much more difficult to install and honestly wouldn't work nearly as well. The Furrion kits by far have the best reception so it wouldn't be worth it to try and find something less expensive as this would give you poor reception overall. view full answer...
Blue Ox has an easy system for determining the weight capacity of your spring bars, whereas other companies may use measurements or printed capacity to assist. With Blue Ox, there is a 5 dimple system: No dimples means it is rated for up to 350 lbs total tongue weight. One dimple means it is rated for up to 550 lbs. Two dimples indicates up to 750 lbs. Three dimples indicates up to 1,000 lbs. Four dimples indicates up to 1,500 lbs tongue weight. Five dimples indicates up to 2,000 lbs total... view full answer...
Since your 2018 GMC Sierra 1500 Denali with the 5-1/2' Bed has the factory MagneRide Suspension the only air helper spring kit available is the Air Lift Ride Control Air Helper Springs - Rear Axle # AL59565. This kit offers 2000lbs of load leveling support and will do a great job to help level your truck when towing a trailer or carrying a heavy payload.
To keep from needing to manually inflate the helper springs each time you are ready to tow a trailer or carry a heavy payload I recommend... view full answer...
The Lippert Solid Stance RV Step Support Kit # LC96BJ that you referenced can install on non-Lippert steps but the requirements are that they are made of steel and have at least 5 inches of ground clearance. view full answer...
The Advent Air RV Air Conditioner # ACM135C referenced in your question should actually work perfectly on a pop-up camper like your 2005 Rockwood because of its smaller size and the fact that it also includes the ceiling vent assembly. This is a non-ducted unit which is the way to go for your camper since it doesn't already have ducts built into it for venting.
This is a really nice system that also comes with a start capacity that uses stored energy to kick on the AC and a built-in thermostat... view full answer...
I can definitely help and point you in the right direction. We have a few lift kits available and it will just depend on exactly what kind of axles you have on your camper. The Lift kit # K71-725-02 that you were looking at will #12 Torflex axles with 5,500-7,000-lb capacities.
I did look up some specs on your camper. I was not able to confirm exactly what axles they put on there, but looking at the GVW and CCC you may have a slightly smaller axle than a 5,500 lb. If this is the case... view full answer...
This is a really great question, but the weight of the weight distribution system actually does not count as additional tongue weight. We've asked our WD system manufacturers and they'd told us that the WD system basically becomes a part of the trailer hitch on the vehicle so it's weight does not get factored. The weight of the Strait Line system part # RP66073 that you referenced is 83 lbs and this does not include a shank. The version of this system that does include a shank part # RP66083... view full answer...
Put the pin back in and wind it 12-16 times rolling it towards the camper to put the correct tension in the slide topper # LCV000163285 before installing it. This will give you the correct amount of tension for extending and retracting the awning. view full answer...
If you can clean up the scarring by sanding it smooth you would be fine but if it's damaged to point you couldn't get it back to being undamaged then it would be time for a new one. We have replacement spindles for the 3,500 lb axle of your trailer with the part # TRU77FR though if you need to replace it. view full answer...
The closest wheel and tire we have to the # LH29FR that has a 5 on 4-1/2 inch bolt pattern is the Taskmaster ST225/75D15 Bias Ply Trailer Tire - Load Range D # TTWSF22515D and the Aluminum Sendel Series T02 Machined Trailer Wheel - 15" x 6" Rim - 5 on 4-1/2 # AM22653 which is a similar wheel design. This is the same size tire that has a capacity of 2,540 lbs and a speed rating of 81 mph. You will need to have the tire mounted to the wheel at a local shop upon delivery. view full answer...
Since 20 foot would include the propane tanks and bike cover that you mentioned for your 2021 Forest River, Geo Pro 19 FBS the best option for a storage cover would be the # 290-52240 which fits up to 20 foot travel trailers and provides the best protection in all climates. It also comes with tire covers as well. view full answer...
For a great cover for your 25.6-foot 2022 Forest River 2516S Mini Lite travel trailer, I recommend the Adco Olefin HD All-Climate + Wind RV Cover for Travel Trailer # AD77ZR. This particular cover fits travel trailers that measure between 24'1" - 26' long. This particular cover comes with cinch ropes at the front and rear to remove slack and reduce billowing. It also comes with built-in vents to allow air to escape. In order to ensure that the cover has enough height with the 96 inches... view full answer...
The perfect solution for you is the Furrion # FMSN09BL wireless camera system. It quickly and easily mounts to your preinstalled Furrion mounting base and plugs into your preinstalled power connector. The receiver/monitor plugs into your dash lighter/power outlet and you are ready to go. view full answer...
The NOCO # 329-GENIUS10 is the ideal charger. Not only can it charge up very large batteries quickly, the batteries can remain connected to the charger indefinately on a maintenance charge. It has many modes that will allow you to charge most batteries - even litihiums. No reason that this can't work in conjunction with solor panels. view full answer...
Go To Results